Coordinates can be added through the Virta system. The coordinates are needed to find the charging points on the map of the application. The coordinates can therefore be changed as follows from the Virta system.
- Click on "Stations" in the top panel and you will be taken to the screen shown in Figure. In this view, you will see the full data of the charging point, but by clicking on the pencil on the top left you can access additional information about the charging point.
- Click “move only this station” as with “move all stations in the pool will change all of one CPO stations under the same coordinates.
- Add coordinates and press save.
- It will take up to few hours before the changes can be seen in the application.